Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 178

configure Notes Enable CLOSE on OPEN received? If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is required for TachLite. The valid range is 0 to 4. The default value is 0. Always send RSCN? Following the completion of loop initialization, a remote state change notification (RSCN) is issued when FL_Ports detect the presence of new devices or the absence of preexisting devices. When set to 1, an RSCN is issued upon completion of loop initialization, regardless of the presence or absence of new or preexisting devices. When set to 0, an RSCN is not sent (default). System Services Settings The values for the System Services settings are as follows: Disable RLS probing Enables or disables the read link status (RLS) probing. Performed by the FCP daemon, RLS probing reads the link error block from the device. This extended link services command is defined by the FC standards. Refer to the FC standards for information. RLS probing is enabled by default, meaning "Disable RLS probing" is "off". "on" disables RLS probing. Portlog Events Enable/Disable Settings These settings determine whether or not various types of port events are logged. Each event type displayed on the screen is enabled by default ("on"). When disabled, this event is not logged by the port log. Application Attributes A number of application attributes are configurable. The following table specifies the attributes for applications that can be modified. Application Field Type Default Range ssl Certificate File string [not-set] varies CA Certificate File string [not-set] varies Length of crypto key number [128] 40,56,128 rpcd Secure RPCd Callback Secret string none varies Webtools Basic User Enabled boolean no no/yes Perform License Checking and Warning boolean yes yes/no Allow Fabric Event Collection boolean yes yes/no Login Session Timeout number 200 60 to (in seconds) 432000 The maximum per port login limit is no longer configurable with this command. Use the portcfgNPIVPort --setloginlimit command to configure this parameter on a per port basis. The Telnet interface is no longer configurable with this command. Use the ipFilter command to enable or disable the Telnet interface. 154 Brocade Fabric OS Command Reference 53-1004112-02