Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 652

portCfg 628 enable Re-enables the inband management interface at the specified GbE Port after it has been disabled. The interface is by default enabled when it is created. mgmtroute Configures the management route for the inband management interface (needed only if the management interfaces are on different subnets). The syntax for mgmtroute is as follows: mgmtroute ge_port [options] destination_ip_address Valid options and arguments for mgmtroute include the following: create Creates a management route for a specified destination IP Address. The following operands are required: dest_IPv4_addr Specifies the destination IP address for the management route in IPv4 format. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. gateway Specifies the IP address of an IP router that can route packets to the destination IP address. delete Deletes a management route for a specified destination IP Address. The following operands are required. dest_IPv4_addr Specifies the destination IP address for the management route in IPv4 format. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. sla Creates. modifies, or deletes an SLA session. For more information on the SLA feature, refer to the Fabric OS Extension Administration Guide. This command supports create, modify, and delete options only. The syntax for portcfg sla is as follows: portcfg sla name option [args] Valid options and arguments for sla include the following: create Creates an SLA session with the specified name. You must create an SLA session at each end of the circuit, but the session names need not match. modify Modifies the specified SLA session. name Specifies the name of the SLA. Brocade Fabric OS Command Reference 53-1004112-02