Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 455

ipAddrShow Local IPv6 addresses display the following identifiers: • IP Address type: - static - A statically configured IPv6 address. - stateless - Acquired through stateless autoconfiguration. • IP Address state: - tentative - preferred - deprecated Refer to the RFC 2462 specification for more information. On modular platforms with intelligent blades, the addresses configured for each slot can be shown with the -slot option. On standalone platforms, all command options are ignored. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: -cp cp_number On dual-CP systems, specifies the CP card number to be displayed (0 or 1). -chassis On dual-CP systems, displays the IP addresses for the chassis. -slot slot Specifies the slot for a blade. -eth0 | -eth1 | -gate For a specified slot, shows only the selected Ethernet interface or the gateway . This operand is optional with the -slot option. Examples To display the IP addresses on a standalone switch: switch:admin> ipaddrshow SWITCH Ethernet IP Address: 10.20.21.204 Ethernet Subnetmask: 255.255.240.0 Gateway IP Address: 10.20.16.1 DHCP: Off IPv6 Autoconfiguration Enabled: Yes Local IPv6 Addresses: dhcpv6 fd00:60:69bc:82:a6f3:568b:a9cc:a149/64 preferred stateless fd00:60:69bc:82:205:33ff:fe94:771f/64 preferred IPv6 Gateways: fe80::21b:edff:fe0b:2400 fe80::21b:edff:fe0b:7800 DHCPv6: On Brocade Fabric OS Command Reference 431 53-1004112-02