Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1052

snmpConfig -mib_name mib_name Specifies the name of the MIB to be configured. This operand is required if you want to configure MIB traps noninteractively. Valid MIB names include the following. • FE-MIB • SW-MIB • FA-MIB • FICON-MIB • HA-MIB • FCIP-MIB • ISCSI-MIB • IF-MIB • MAPS-MIB • T11-FC-ZONE-SERVER-MIB -bitmask bit_mask Specifies the bit mask for the MIB. Refer to the table above for valid values. -trap_name trap_name Specifies the name of the trap to be enabled or disable. This operand is optional. Use snmpconfig --show mibcapability for a listing of valid traps. accessControl Selects access-control-related parameters. These parameters include the access host subnet area and access permission (read-write). -host ip_address Specifies the host IP address with or without a subnet mask. -access [ro | rw Specifies the read-write (rw) or read-only (ro) access to the host. systemGroup Selects configuration parameters related to the system group. -sysdescr sysdescr Specifies the system description. The default value is "Fibre Channel Switch". -syslocation syslocation Specifies the location of the system (switch). The default value is "End User Premise". The string must be at least 4 characters in length; the maximum length is 255 characters. If special characters are used in the syslocation, the syslocation must be enclosed in single quotes. -syscontact syscontact Specifies the contact information for this system (switch). The default value is "Field Support". Refer to the definition of sysDescr, sysLocation and sysContact in the system group of MIB-II. The string must be at least 4 characters in length; the maximum length is 255 characters. If special characters are used in the syscontact, the syscontact must be enclosed in single quotes. 1028 Brocade Fabric OS Command Reference 53-1004112-02