Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1049

snmpConfig fruStatusChanged (1) 0x2 Enabled cpStatusChanged (2) 0x4 Enabled fruHistoryTrap (3) 0x8 Enabled FCIP-MIB 0x1 Enabled IF-MIB 0x1 Enabled linkUpTrap (3) 0x8 Enabled linkdownTrap (4) 0x10 Enabled MAPS-MIB 0x1 Enabled mapsTrapAM (1) 0x2 Enabled T11-FC-ZONE-SERVER-MIB 0x1 Disabled t11ZsRequestRejectNotify (1) 0x2 Disabled t11ZsMergeFailureNotify (2) 0x4 Disabled t11ZsMergeSuccessNotify (3) 0x8 Disabled t11ZsDefZoneChangeNotify (4) 0x10 Disabled t11ZsActivateNotify (5) 0x20 Disabled Note: The Zone Mib parameters are for restricted usage only. Use the --show mibcapability option to display the traps configurable under each MIB. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Informs are not supported for IPv6 addresses. Operands This command has the following operands: --help Displays the command usage. --enable Enables the SNMP agent configuration for the specified category. This operand is valid only with mibcapability and snmpv1. When used with the snmpv1 operand, this command restores access to SNMPv1/v2c. --disable Disables the SNMP agent configuration for the specified category. This operand is valid only with mibcapability and snmpv1. When used with the snmpv1 operand, this command blocks access to SNMPv1/v2c. All requests for v1/v2c version will be dropped by the switch, and SNMPv1 traps will be blocked from being sent, even if trap destinations are present. --show Displays the SNMP agent configuration data of the specified category. When used with the snmpv1 operand, this command displays whether access to SNMPv1/v2c is enabled or disabled. --set Sets the SNMP agent configuration data of the specified category. Brocade Fabric OS Command Reference 53-1004112-02 1025