Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 861

portShow Description Notes Use this command to display FCIP-related configuration parameters on the Brocade 7840 switch, on the Brocade SX6 extension blade, and on the Brocade FX8-24 blade. The parameters displayed by this command are set with the portCfg command. The following displays are supported with this command: • portshow ipif - Displays the local IP interfaces. • portshow iproute - Displays static routes on the IP interface. • portshow arp - Displays the content of the address resolution protocol (ARP) table. • portshow vlantag - Displays the IP interface VLAN configuration. Supported on the Brocade FX8-24 only. • portshow autoneg - Displays autonegotiation status. • portshow ipsec-policy - Displays IPSEC Policy information. Supported on Brocade 7840 switch and the Brocade SX6 extension blade only. • portshow mgmtif - Displays the inband management interfaces. • portshow mgmtroute- Displays the routes for the inband management interfaces. • portshow lag - Displays the static link aggregation group (LAG) information. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. • portshow tcl - Displays the Traffic Control List (TCL) information. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. • portshow lan-stats - Displays the LAN statistics. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. • portshow sla - Displays the SLA statistics. Supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. IPv6 addresses are supported. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be displayed, followed by a slash (/). ge_port Specifies the number of the GbE port to be displayed relative to the slot number. The GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade. The 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. Brocade 7840 switch and the Brocade SX6 extension blade have two 40GbE ports labeled ge0 and ge1, and 16 1 or 10GbE ports labeled ge2-ge17. Use the switchShow command for a listing of valid ports ipif Displays the IP interface ID, IP address, netmask, and MTU for IPv4 addresses. Displays the prefix instead of the netmask for IPv6 addresses. Flags are explained in the command output (refer to the example below). --link-local Displays the link-local interface addresses. iproute Displays the IP address, netmask, gateway, metrics, and flags. Displays the prefix instead of the netmask for IPv6 addresses. Brocade Fabric OS Command Reference 837 53-1004112-02