Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 683

portCfgDefault portCfgDefault Resets the port configuration to factory default value. Synopsis portcfgdefault [slot/][ge]port portcfgdefault --help Description Use this command to reset all configuration values on a specified port to their factory defaults. This command persistently disables ports capable of routing, which is the factory default value. Use the portCfgShow command to display the port configuration. This command does not change the state of a port. To change the state of an E_Port, use either switchDisable/switchEnable or portDisable/portEnable. When this command is used to reset an F_Port in an Access Gateway, that F_Port is unmapped from its mapping to an N_Port. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be reset, followed by a slash (/). port Specifies the number of the port to be reset, relative to its slot for bladed systems. Use switchShow to list of valid ports. --help Displays the command usage. Examples To reset a port to factory defaults: switch:admin> portcfgdefault 1/3 To reset a GbE port to factory defaults: switch:admin> portcfgdefault 8/ge1 SEE ALSO portCfgEport, portCfgGport, portCfgLongDistance, portCfgLport, portCfgPersistentDisable, portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort Brocade Fabric OS Command Reference 659 53-1004112-02