Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 881

portShow -rtt ms Filters the output based on the specified circuit round trip time in milliseconds. -connect-count value Filters the output based on the connected count exceeding specified value. -bps value[k | m] Filters the output based on bandwidth (bytes per second) exceeding the specified value. Specify k for KBps and m for MBps. -or The logical OR operator. -and The logical AND operator. -default show | hide Sets the default display action if the specified filter statement is not supported. The default action is hide. Examples To display FCIP tunnel configuration parameters on the Brocade SX6 blade with Ficon enabled: switch:admin> portshow fciptunnel 8/27 -d Tunnel: VE-Port:8/27 (idx:11, DP1) Oper State : Online TID : 219 Flags : 0x00000000 IP-Extension : Disabled Compression : None QoS BW Ratio : 50% / 30% / 20% Fastwrite : Enabled Tape Pipelining : Read/Write IPSec : Disabled Load-Level (Cfg/Peer): Failover (Failover / Failover) Local WWN : 10:00:00:05:33:e7:d2:13 Peer WWN : 10:00:00:05:33:65:a8:05 RemWWN (config) : 00:00:00:00:00:00:00:00 FICON : Enabled XRC : Enabled Tape Pipelining : Read/Write Read Block id : Enabled Tin Tir : Enabled DevAck : Enabled Tera Read : Disabled Tera Write : Disabled Print : Disabled FICON Max Read Pipe : 32 FICON Max Write Pipe : 32 FICON Max Read Devs : 16 FICON Max Write Devs : 16 FICON Write Timer : 300 FICON Write Chain : 3200000 FICON OXID Base : 0x8000 FICON Debug Flags : 0x77c90000 cfgmask : 0x003fc7ff 0x40000208 Flow Status : 0 ConCount/Duration : 1 / 35m19s Brocade Fabric OS Command Reference 857 53-1004112-02