Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 648
vlantag, delete, portcfg, crossport, ipsec-policy
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 648 highlights
portCfg vlantag Use this command to maintain the VLAN tag table associated with a particular network interface. This command is suppoted on Brocade FX8-24 blade. This table is mainly used during ingress processing to filter VLAN tagged frames. You can configure multiple VLAN IDs per IP interface; however, if you provide a destination address, there cannot be two entries to the same destination, including 0.0.0.0. Egress frames already marked as VLAN tagged (FCIP circuit-level tagging) take precedence over entries in this table. This command supports add and delete options only. To modify a table entry, it must first be deleted, then added with different configuration parameters. The syntax for portcfg vlantag is as follows: portcfg vlantag [slot/]ge_port mode arguments Valid modes for vlantag include the following: add ipif_addr vlan_id l2cos [dst_ipaddr][optional_args] Adds an entry to the VLAN tag table. delete ipif_addr vlan_id [dst_ipaddr] Deletes an entry from the VLAN tag table. Valid arguments for add and delete include the following: ipif_addr Specifies the locally defined interface address in IPv6 or IPv4 format. vlan_id Specifies the VLAN ID used for this tag. The range is 1 to 4094. l2cos Specifies Layer 2 Class of Service/Priority, as defined in the IEEE 802.1p specification. The range is 0 to 7. Valid only with the add option. dst_ipaddr Specifies an optional destination IP address (IPv4 or IPv6). All packets destined for this IP address are tagged accordingly. If a destination IP address is not specified, all packets not already tagged will be tagged. The default is 0.0.0.0. optional_args Optional VLAN tagging parameters include the following: -x | --crossport >Applies the VLAN tag to a crossport interface. Specifying this parameter allows the VE_Ports 12-21 to use the IP interface with this vlantag. This operand is optional and valid only and supported only on the Brocade FX8-24 XGE ports. -m | --mgmt Specifying this parameter applies the VLAN tag to the inband management interface. ipsec-policy Creates an IPsec policy. This option is supported on the Brocade 7840 switch and the Brocade SX6 extension blade only. 624 Brocade Fabric OS Command Reference 53-1004112-02
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/648.png)