Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 804

portErrShow portErrShow Displays a port error summary. Synopsis porterrshow porterrshow [[slot/]port1[-[slot/]port2]] porterrshow -i | -index [index1[-index2]] porterrshow -x [hex1[-hex2]] porterrshow --help Description Use this command to display an error summary for a port or a range of ports. Counts are reported on frames transmitted by the port (Tx) or on frames received by the port (Rx). The display contains one output line per port. Numeric values exceeding 999 are displayed in units of thousands (k), millions (m), or giga (g) if indicated. You can identify a single port to be configured by its port number or by its port index number in decimal or hexadecimal format. Port ranges are supported with port numbers, index numbers (decimal or hexadecimal) or by specifying a slot or a slot range. Use switchShow for a listing of valid ports, slots, and port index numbers. When used without operands, this command displays error summary for all ports on the switch. Specifying multiple ports with the index number (-i or -x) or slot (-s) option is supported only if PortSwap is disabled. They are not supported on GbE ports and configured F_Port trunks. Use the -i option without a port index argument to display the portSwap status, or alternately use portSwapShow. Values for the following parameters are displayed: frames tx Number of frames transmitted (Tx). frames rx Number of frames received (Rx). enc in Number of encoding errors inside frames received (Rx). crc err Number of frames with CRC errors received (Rx). crc g_eof Number of frames with CRC errors with good EOF received (Rx). too shrt Number of frames shorter than minimum received (Rx). too long Number of frames longer than maximum received (Rx). bad eof Number of frames with bad end-of-frame delimiters received (Rx). enc out Number of encoding error outside of frames received (Rx). 780 Brocade Fabric OS Command Reference 53-1004112-02