Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 73

agShow Notes NPIV capability should be enabled on the ports connected to the Access Gateway. NPIV capability is enabled by default. Use portCfgNPIVPort to enable NPIV capability a port if it was previously disabled. Note that enabling or disabling NPIV capability is no longer supported in Access Gateway mode. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following optional operands: --name ag_name Displays information regarding a specific Access Gateway that is registered with this fabric. --local Display information regarding all Access Gateways that are locally registered to this switch. Examples To display the Access Gateway information registered with the fabric: switch:admin> agshow --name core_ag Name : core_ag NodeName : 10:00:00:05:1e:85:ae:f8 N-Port ID(s) : 0x010100,0x010d00,0x010c00,0x010e00,0x010f00 Number of Ports : 40 IP Address(es) : 10.17.31.2 Firmware Version : v7.1.0ING N-Ports : 5 F-Ports : 5 Attached F-Port information : PortID Port WWN Switch F-port 0x010101 10:00:00:05:1e:65:95:81 0 0x010102 20:01:00:05:1e:85:92:88 0 0x010d01 20:02:00:05:1e:85:92:88 13 0x010c01 20:03:00:05:1e:85:92:88 12 Access Gateway F-Port Information : F-Port NumberF-Port IDF-Port WWN 23 0x01010120:17:00:05:1e:85:ae:f8 To display the locally registered Access Gateways: switch:admin> agshow --local Worldwide Name Ports Enet IP Addr Firmware \ 10:00:00:05:1e:04:06:ae 24 10.32.173.64 v6.4.0 \ Local/Remote Name local L5D_B14_4024_1 To display all Access Gateways attached to the fabric: switch:admin> agshow Worldwide Name Ports Enet IP Addr Firmware \ 10:00:00:05:1e:02:b7:2c 16 10.32.173.62 v6.4.0 \ 10:00:00:05:1e:04:06:ae 24 10.32.173.64 v6.4.0 \ 10:00:00:05:1e:04:06:ae 24 10.32.173.51 v6.4.0 \ Brocade Fabric OS Command Reference 49 53-1004112-02