Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 338

ficonCupSet ASM DCAM ACP HCP MIHPTO seconds CRP PID CHID PID CHID Active=saved mode Director clock alert mode Alternate control prohibited Host control prohibited Sets the missing interrupt handler primary timeout (MIHPTO) value for the CUP. The following operand is required: Specifies the timeout value in seconds. Provide a decimal value in the range between 15 and 600 seconds. The default timeout value is 180 seconds. If a value greater than 63 seconds is specified, the timeout value is rounded down to the closest value divisible by 10. For example, an MIHPTO timeout value of 86 defaults to 80. Sets the current reporting path (CRP). The reporting path is a CUP mechanism for sending FRU-failure reports to a FICON logical path via FICON protocol. The logical path between the PID and the CHID must exist and be in operational state for this command to succeed. Use ficonCupShow with the LP option to display the logical paths on the switch. The following operands are required: Specifies the Port identifier, which is a three-byte Fibre Channel Port Address. Specifies the Channel ID (CHID). The CHID is the Logical Partition (LPAR) identifier supplied as part of the FICON protocol header. The CHID is a 1-byte value in hexadecimal format. The first nibble indicating the Channel Subsystem identifier (a value between 0 and 3) and the second the LPAR within that CSS (a value between 0 and F). Examples To enable FMS mode for the switch: switch:admin> ficoncupset fmsmode enable fmsmode for the switch is now Enabled To set the ASM bit in the mode register for the switch: switch:admin> ficoncupset modereg ASM 1 Active=Saved Mode bit is set to 1 To set the MIHPTO value to 60 seconds: switch:admin> ficoncupset MIHPTO 60 MIHPTO has been changed to 60 seconds To set the current reporting path: switch:admin> ficoncupset CRP 082300 1A 314 Brocade Fabric OS Command Reference 53-1004112-02