Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 658
Function, Synopsis, Description, Notes, Operands
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 658 highlights
portCfg To enable the autonegotiation of a 1GbE port: switch:admin> portcfg autoneg 1/ge2 --enable Operation Succeeded switch:admin> portshow autoneg 1/ge2 Auto-Negotiation Configuration: Port: 1/ge2 Auto-Negotiate: Enabled To create an SLA session: switch:admin> portcfg sla netA create --loss 0.5 \ --runtime 15 --timeout 60 Operation Succeeded Function Configure tunnels, circuits, and management interfaces on the Brocade 7840 switch and Brocade FX8-24 and Brocade SX6 extension blades. Synopsis portcfg action [slot/]ve_port options arguments Description Notes Use this command to configure FCIP tunnels and FCIP circuits on the Brocade 7840 switch, and the Brocade FX8-24 and Brocade SX6 extension blades only. The FCIP tunnels on the local and remote ports act as Virtual E_Ports (VE_Ports) connecting the local and remote fabrics. The following operations can be performed with this command: • portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels. - Configure a tunnel with the FCIP FastWrite feature. - Enable or disable Tape Pipelining. - Configure the compression options. - Configure an IPsec-enabled tunnel. - Configure VLAN tagging on the default FCIP circuit. This option is supported on Brocade FX8-24 blade only. - Configure Differentiated Services Code Point (DSCP) markings. - Set the committed rate or minimum and maximum rates for the default circuit. - Configure a tunnel for FICON emulation. • portcfg fcipcircuit - Create, modify, and delete additional FCIP circuits. - Set or modify the committed rate or minimum and maximum rates for the circuit. - Configure or change VLAN tagging on the default circuit. - Set or modify additional circuit parameters. You can configure up to 20 tunnels on the Brocade 7840 switch, and on the Brocade FX8-24 and Brocade SX6 extension blades. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). 634 Brocade Fabric OS Command Reference 53-1004112-02
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/658.png)