Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 776
ipperf, portCfg, traceroute, crossport, service_type, wait_time, vlan_id, L2 Class-of-Service, dst_ip
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 776 highlights
portCmd -q service_type Specifies the type of service in the ping request. The default is 0 and service_type can be hex (0x0-0xFF) or decimal (0-255). This operand is optional. -t ttl Specifies the time to live. Valid values are 1 to 255. The default is 100. This operand is optional. -w wait_time Specifies the time to wait for the response of each ping request in seconds. The default is 5 seconds and the maximum wait time is 9 seconds. This operand is optional. -z size Specifies the default packet size to a fixed size in bytes. The default is 64 bytes. In an IPv4 environment, the ICMP/IP header occupies 28 bytes. In an IPv6 environment it occupies 48 bytes. The total size, including ICMP/IP headers (28 or 48 bytes without IP options) cannot be greater than the IP MTU configured on the interface. This operand is optional. -v vlan_id Specifies the VLAN ID. Values must be in the range between 1 and 4094. There is no default value. Note that a VLAN tag entry must exist on the local and remote sides prior to issuing the -v option. A VLAN Tag table entry is dynamically maintained by the ipperf application. See the portCfg help page for details on creating a VLAN tag table. This option is supported on Brocade FX8-24 blade only. -c L2 Class-of-Service Specifies Class of Service/Priority, as defined by IEEE 802.1p. Values must be in the range between 0 and 7. The default is 0. This operand is optional with the -v option. --traceroute Traces the IP router hops used to reach the host dst_ip from one of the source IP interfaces on the GbE port. Valid arguments include the following: -s src_ip Specifies the local IP address to use for sourcing the probe packets. IPv6 addresses are supported. -d dst_ip Specifies the destination IP address to which to probe the IP router path. IPv6 addresses are supported. -x | -crossport Specifies the source IP address as a crossport. A crossport is the nonlocal (secondary) XGE port to a VE_Port group that provides failover capabilities for the tunnel configured on the local XGE port. This operand is optional and supported only on the Brocade FX8-24 XGE ports. -m max_hops Specifies the maximum hop limit used in the outgoing probe packets. The default value is 30 hops. This operand is optional. 752 Brocade Fabric OS Command Reference 53-1004112-02