Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1051
Auth/NoPriv
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1051 highlights
snmpConfig -enable | -disable [informs] Enables or disables informs. If informs are enabled, all trap destinations receive inform requests. If informs are disabled, all trap destinations receive trap requests. When informs are enabled, the engine ID must be set to correspond to the management engine IP address. Informs are by default disabled. IPv6 Informs are currently not supported. -user user_name Specifies the name of the user that connects to the agent. The user name must be between 2 and 32 characters long. The default user names are defined with the noAuth and noPriv protocol. The factory default SNMPv3 user names include the following: • User 1: snmpadmin1 • User 2: snmpadmin2 • User 3: snmpadmin3 • User 4: snmpuser1 • User 5: snmpuser2 • User 6: snmpuser3 -auth_proto auth_protocol Specifies the authentication protocol as MD5, SHA, or no authentication for each entry. The following combinations of protocols are supported: • NoAuth/NoPriv • Auth/NoPriv • Auth/Priv -auth_passwd auth_password Specifies the authentication password that enables the agent to receive packets from the host. Passwords are plain text and must be added each time for each configuration replay. The password must be between 1 and 32 characters long. -priv_proto priv_protocol Specifies privacy authentication level setting. The vald values are DES and AES128. -priv_passwd priv_password Specifies the privacy password that enables the host to encrypt the contents of the message that it sends to the agent. Passwords are plain text and must be added each time for each configuration replay. The privacy password alone cannot be configured. You configure the privacy password with the authentication password. -engine_id engine_id Configures a user-defined engine ID for the SNMP agent. -notify_type trap | informs Specifies the type of notification traps that are sent for the host. Traps and informs are supported. The default notify type is traps. --set mibcapability Configures MIBs. Brocade Fabric OS Command Reference 53-1004112-02 1027
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/1051.png)