Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 177

configure non-NPIV F-Ports. When mode is set to 2, on FLOGI login the first FLOGI takes precedence. On FDISC login, the second FDISC takes precedence. For more information, refer to "Configure FLOGI-time handling of duplicate PWWNs" section in the Fabric OS Administrator's Guide. You must disable the switch to change this parameter. MAX num. of FLOGIs allowed Specifies the number of FLOGIs the port can accept per second. The default value is 100. When the FLOGI limit is reached, the port will be fenced. Zoning Operation Parameters The following zoning operation parameter can be modified. Disable NodeName Zone Checking Specify 1 to disable using node WWN when specifying nodes in the zone database. Specify 0 to enable using node WWN when specifying nodes in the zone data. The default value is 0. This value must be set to 1 for interpretability. Local TI Filtering Specify on to enforce TI zone rules on the local devices. The default value is off. You must first disable the switch using the switchDisable command before enabling this feature. RSCN Transmission Mode The RSCN transmission modes and values are as follows: End-device RSCN Transmission Mode Values are as follows: 0 RSCN only contains single PID 1 RSCN contains multiple PIDs (Default) 2 Fabric addresses RSCN Domain RSCN to End-device Values are as follows: 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop Parameters Arbitrated Loop Parameter and their values are as follows: Send FAN frames? Specifies that fabric address notification (FAN) frames be sent to public loop devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0, frames are not sent. The default value is 1. Brocade Fabric OS Command Reference 153 53-1004112-02