Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1176

zone 1152 --delete name Deletes TI zones from the defined TI zone lists. This command prompts for confirmation. --show [name] Displays zone name, port lists, failover option, configured status and, the active status for the specified zones. The configured status reflects the latest change that may or may not have been activated. The active status reflects the state that is activated by cfgEnable. Without any specified name, this command displays all TI zones in the defined configuration. The following operands are optional: -ic Displays all TI zone configurations for a given zone name without case distinction. -ascending Displays the TI zone members in ascending order. --showTIerrors Analyzes real and potential routing problems with the activated TI zoning set and prints a report. This command must be executed in the local domain and analyzes only that domain. --showTItrunkerrors Displays details of the trunk members present in the TI zone and those not present in the TI zone. 3. Creating and managing RD Zones --rdcreate Creates a RD Zone for the specified members. The following operands are required: host_wwn Specifies the port world wide name of the host. target_wwn Specifies the port world wide name of the target. vi_wwn Specifies the port world wide name of the virtual initiator (VI). vt_wwn Specifies the port world wide name of the virtual target (VT). policy restartable | nonrestartable Specifies the policy as either restartable or nonrestartable. A restartable policy causes traffic flow to revert to the physical host and target configuration in the event the virtual device should fail. When the policy is specified as nonrestricted and one of the virtual devices goes offline, the physical devices are considered offline and no traffic is allowed between the original host and target. FCR | noFCR Indicates whether or not this RD zone should function across a Fibre Channel router (FCR). Specify FCR to support FCR. Specify noFCR if you do not wish to support FCR. --rddelete name Deletes the RD Zone specified by name. RD Zones are unique in that the zone name is not user-defined. It is derived based on members and the specified configuration. Use cdfgShow to display currently implemented RD zone by name. Brocade Fabric OS Command Reference 53-1004112-02