Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 624

pathInfo --help Displays the command usage. When executed without operands, pathInfo runs interactively. Specifying a destination switch is required; the values for the source and destination ports can be -1 to indicate the embedded port. You must specify the source and destination PID to display the correct TI-enabled path information across the FCR. Reverse-path tracing is optional. In addition, this command prompts for the following parameters: Max hops The maximum number of hops that the pathInfo frame is allowed to traverse; the default is 25. Fabric Id Specifies the Fabric ID. If unspecified, the value defaults to -1 (Default switch FID 128) Domain|Wwn|Name Specifies the domain ID or WWN. Source port Specifies the port whose path to the destination domain is traced, specified as the port index. If unspecified, the value defaults to -1 (embedded port). Destination port Specifies the port on the destination switch for the path being traced. If unspecified, the value defaults to -1 (embedded port) Source pid Specifies the source ID of the originator device in hexadecimal format. Destination pid Specifies the destination ID of the proxy device in hexadecimal format. Basic stats Whether basic statistics are generated on every link; the default is no. Extended stats Whether extended statistics are generated on every link; the default is no. Trace reverse path Specifies the path information in reverse direction; the default is no. Source route Specifies a sequence of switches or ports that the pathInfo frame should traverse; the default is no. If an output port to the next hop is specified, you are not prompted for the domain of the next switch. The domain is determined by the port. Timeout The maximum time allowed waiting for the response in milliseconds. The default is 10000 milliseconds. 600 Brocade Fabric OS Command Reference 53-1004112-02