Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 533

mapsConfig -type member_type Specifies the type of elements on which to pause monitoring. Valid types include the following: port The elements are FC ports. circuit The elements are FCIP circuits. sfp The elements are SFP transceivers. -members member_list Specifies the specific elements on which to pause or continue monitoring. The member list must be enclosed in double quotation marks and can consist of the following: Port and SFP groups: • A single port, for example, "8" or "2/8" on bladed systems. • A port range where the beginning and end port are separated by a dash, for example, "8-13" or "2/8-13" on bladed systems. • A set of ports and port ranges separated by commas, for example, "3,5,7-10,15" or "2/3,2/5,3/7-10,4/15" on bladed systems. Circuit groups: • A single circuit in VE_Port/circuit format, for example, "33/5". • A circuit range in VE_Port/circuit format, for example, "33/1-3". • A set of circuits separated by commas, for example, "33/1-3,33/5". --actions actions_list Specifies a comma-separated list of all of the actions that are allowed globally on the switch. Any actions listed for a specific rule must also be listed here to take effect. Valid actions include the following: raslog Generates a RASLog message. decom Decommissions the port. Use this action along with fence. fence Fences the port, if port fencing is enabled. Port fencing takes the ports offline if the rule thresholds are exceeded. This action is valid only on conditions that are evaluated on ports. snmp Generates an SNMP trap. email Sends information about a switch event to a specified e-mail address. sfp_marginal Sets the state of the affected SFP transceiver to marginal. This action is valid only if the monitoring system (specified by the monitor operand in the mapsRule command) is one of the switch policy status monitoring systems: CURRENT, RXP, TXP, VOLTAGE, SFP_TEMP. Brocade Fabric OS Command Reference 509 53-1004112-02