Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 86

auditCfg auditCfg Modifies and displays the audit log filter configuration. Synopsis auditcfg --class audit_class auditcfg --enable | --disable auditcfg --severity severity_level auditcfg --show Description Use this command to configure the audit logging and to display the audit log configuration. This command allows you to set filters by configuring certain classes, to add or remove any of the classes in the filter list, to set severity levels for audit messages, and to enable or disable audit filters. Based on the configuration, certain classes are logged to syslog for auditing. Syslog configuration is required for logging audit messages. Use the syslogAdmin command to add the syslogd server IP address. Notes The RAS class is not configurable; its function is to audit the audit log management operations and it is always enabled internally. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: --class Configures filters for a specified audit class. To add or remove any of the classes in the filter list, reissue the --class option. audit_class Specifies the filters to be configured. Valid values are: 1-ZONE, 2-SECURITY, 3-CONFIGURATION, 4-FIRMWARE, 5-FABRIC, 7-LS (Logical Switch), 8-CLI, and 9-MAPS. The filter is specified by its numeric value. To add more than one filter, the numeric values must be separated by commas. Spaces are not permitted. This operand is required. --severity Sets audit severity level to a specified value. When severity is set, only log messages of type severity_level and higher are displayed. You cannot enter multiple severity levels. severity_level Valid values are INFO, WARNING, ERROR, and CRITICAL. By default, all messages are logged. This operand is required. --enable Enables all filters. This action enables an existing configuration; it does not change the configuration. --disable Disables all filters.This action disables an existing configuration; it does not change the configuration. 62 Brocade Fabric OS Command Reference 53-1004112-02