Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 750

portCfgShow Displays supported only on the Brocade 7840 switch, and Brocade FX8-24 and Brocade SX6 blades Use this command with optional arguments to display the following parameters configured for a GbE port on the Brocade 7840 switch and on the Brocade FX8-24 and Brocade SX6 blades. • IP interfaces on the GbE port • Static routes on the IP interfaces • Address resolution protocol (ARP) entries • VLAN tag configuration • Fibre Channel over IP (FCIP) tunnel configuration settings • IPSec configuration • Inband Management IP addresses and routes. • Display IPsec policy. Currently supported on the Brocade 7840 and Brocade SX6 blade only. Non-GbE port displays The following information is displayed when the command is issued for all ports, for a single port, or for one or more port ranges specified by their port index numbers or slot numbers: Area Number Displays the port area number. This field is displayed only when portCfgShow is executed for a single port. Octet Speed Combo Displays the speed configuration for a port octet. This value is set by the portCfgOctetSpeedCombo command. Port octet speed configuration is supported only on 16 Gbps-capable platforms. On unsupported platforms the Octet Speed Combo field is suppressed. Valid Octet Combo values include the following: 1 Autonegotiated or fixed port speeds of 16 Gbps, 8 Gbps, 4 Gbps, and 2 Gbps. 2 Autonegotiated or fixed port speeds of 10 Gbps, 8 Gbps, 4 Gbps, and 2 Gbps. 3 Autonegotiated or fixed port speeds of 16 Gbps and 10 Gbps. Speed Displays Auto for auto speed negotiation mode, or a specific speed of 1 Gbps, 2 Gbps, 4 Gbps, 8 Gbps, or 16 Gbps, and soft, 10, or AX on 8 Gbps. This value is set by the portCfgSpeed command. Fill Word (On Active) Displays the fill word setting that will take effect after the next time the port goes offline and comes back Possible values are 0(Idle-Idle), 1(arbff-arbff), 2(Idle-arbff), or 3(A-A then SW I-A).This parameter is set by the portcfgFillword command. Fill Word (Current) Displays the currently effective fill word setting. Possible values are 0(Idle-Idle), 1(arbff-arbff), 2(Idle-arbff), or 3(A-A then SW I-A). This parameter is set by the portcfgFillword command. 726 Brocade Fabric OS Command Reference 53-1004112-02