Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 260

faPwwn The following information is displayed for both AG and FC switch ports: PID Port ID. Enable Displays "yes" if the configuration is enabled; displays "No" if the configuration is disabled. MapType Displays the type of mapping: Access Gateway (AG) or switch port (port), user-assigned (user) or automatically assigned (auto). Notes This command is supported only on the Brocade DCX 8510-4 and DCX 8510-8,and the and Brocade 6510. The AG port must be configured on the switch to which the AG is connected. However, both AG switches are FA-PWWN-aware, which means that they can connect to switches with configured FA-PWWN ports. Refer to the Release Notes for other restrictions that may apply. You cannot enable the FA-PWWN feature if portSwap is enabled on the ports. The operands, --assign, --delete, --enable, and --disable can be executed only on a disabled port (switch ports and AG ports). You must re-enable the ports to come online with the new configuration. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands this command has the following operands: --enable Enables the FA-PWWN feature on the specified switch ports or AG ports. If a FA-PWWN is not available for the ports, this command automatically assigners FA-PWWNs to the ports. The switch ports must be disabled using the portDisable command before executing this command. --disable Disables the FA-PWWN feature on the specified switch ports or AG ports. This commands disables the binding of any existing FA-PWWNs to the specified ports, it does not delete the port configurations themselves. When you re-enable the feature, the persistently saved configurations are re-applied to the ports. --assign Assigns a FA-PWWN to a specified port. You can specify only a single port with this command (not a port range) and optionally provide a VPWWN. The switch ports must be disabled using the portDisable command before executing this command. When executed without the -v option, this command automatically generates a FA-PWWN and assigns it to the port. When executed with the -v option, and a user-assigned FA-PWWN already exists, this command fails with an appropriate message. If an automatically assigned FA-PWWN exists, the user-generated FA-PWWN overrides the automatically generated FA-PWWN. When you assign a FA-PWWN to an AG port, you must specify the AG node WWN to uniquely identify the AG. The new FA-PWWN will take effect upon the next login session. 236 Brocade Fabric OS Command Reference 53-1004112-02