Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 687

portCfgEncrypt portCfgEncrypt Configures a port for encryption. Synopsis portcfgencrypt --enable [slot]/port portcfgencrypt --disable [slot]/port portcfgencrypt --help Description Use this command to configure a port for encryption. This command enables or disables the encryption configuration on the specified port and saves the configuration persistently. Before you can configure a port for encryption, you must configure the port for authentication. When disabling encryption, you must disable the encryption configuration before you can disable authentication. Refer to the Fabric OS Encryption Administrator's Guide for more information. Configuring a port for encryption is disruptive. You must disable the port before you can enable encryption on the port. This command fails on an enabled port. The number of configurable ports is limited per ASIC. Use the portEncCompShow for a listing of configurable ports per ASIC. Notes This command is supported on E_Ports and EX_Ports. An E_Port or EX_Port can be enabled for compression and for encryption at the same time. When you move a configured port to another logical switch, you are informed that the operation requires that the port configuration be disabled. You are given the choice to cancel the move or to continue. If you want to go ahead with the move and the port is configured for encryption or compression, you must disable the configuration prior to moving the port. You must reconfigure the port on the target switch if you want to use compression or encryption on that port. This command is supported only on 16 Gbps-capable platforms running Fabric OS v7.0.0 or later with the exception of the Brocade 6505 switch and the Brocade FC8-32E and Brocade FC8-48E port blades. Encryption feature is not supported on 16 Gbps-capable Inter Chassis Link (ICL) ports. On 16 Gbps-capable platforms, both encryption and compression features are supported. On 32 Gbps-capable platforms, only compression is supported and encryption is not supported. The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operands: slot On bladed systems only, specifies the slot number of the ports to be configured, followed by a slash (/). port Specifies the port to be configured. Brocade Fabric OS Command Reference 663 53-1004112-02