Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 685
Removes the ports from the provision list.
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 685 highlights
portCfgDPort Do not run D_Port tests on more than eight links at a time for normal (not long distance) links on FC16-64 blade. On a FC 16-64 blade, do not enable the On-Demand D_Port with bladeInsert or slotPowerOn. Run D_Port test on one link at a time for 100 Km long distance ports on FC 16-64 blade. D_Port tests on other long distance links must be started only after the D_Port test completes on the previous long distance link. Operands This command has the following operands: slot On bladed systems only, specifies the slot number of the ports to be configured, followed by a slash (/). port_list --enable Specifies one or more ports, relative to the slot on bladed systems. Use switchShow for a listing of valid ports. A port list should be enclosed in double quotation marks and can consist of the following: • A single port, for example, "8" or "5/8" on blades systems. • A port range where beginning and end port are separated by a dash, for example, "8-13" or "5/8-13" on blades systems. A port range cannot span multiple slots. • A set of ports separated by commas, for example "3,5,7,8" or "5/3,5,7,8" on bladed systems. • A wildcard * indicates all ports. The wildcard can be represented as '*' or "*". Configures the specified port(s) as D_Port. You cannot configure the port as a D_Port while Dynamic D_Port tests are in progress on the port. The operation fails with an error message. -dwdm Skips the optical loopback test when you run the D_Port diagnostics over a Dense Wavelength Division Multiplexing (DWDM) link or any third party equipment that connects two switches. This operand is optional. --disable Clears the D_Port configuration on the specified ports. -dwdm Disables DWDM mode on the port. This operand is optional. --provision List of ports that are marked to be set as D_Ports. Use the --enable command to configure one or more ports from the list as D_Ports. -add Adds the ports on the provision list to be configured as D_Ports. -dwdm Provisions the specified ports for DWDM. This operand is optional. -delete Removes the ports from the provision list. -dwdm Disables DWDM provisioning on the specified ports. This operand is optional. Brocade Fabric OS Command Reference 661 53-1004112-02
![](/manual_guide/products/dell-brocade-g620-brocade-801-fabric-os-command-reference-c7958e0/685.png)