Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 534

mapsConfig sddq Isolates the slow-drain flows to a low priority VC from the existing VC (medium or high) thus freeing up the resources for the regular flows in the existing VC. Th slow drain device quarantine (SDDQ) feature is not supported in the Access Gateway mode. fms Notifies the configured MAPS threshold events to the FICON Management Server (FMS). toggle Enables port toggling to recover a port from bottleneck condition caused by the target device. Port toggle is supported only for the F_Ports. none No actions are allowed on the switch. Specifying this option allows you to turn off all notifications. The actions SW_CRITICAL and SW_MARGINAL are always enabled by default. --emailcfg Specifies the configuration for e-mail notifications, if email is a triggered action. You can configure a relay host IP address using the relayConfig command. -address email_address Specifies the e-mail address to which the notifications are sent. You can configure up to 5 e-mail addresses as the alert message's receiver. Multiple e-mail addresses must be separated by a comma and each e-mail address can be up to a maximum length of 128 bytes. The e-mail address must conform to standard syntax: [email protected]. Invalid e-mail addresses are rejected. "NONE" is the default address and a valid input parameter. --testmail Sends the test e-mail with the default subject and message along with the switch name in the message. The command fails if the e-mail address is not configured. -subject subject Specifies the user-defined subject line for the test e-mail. This operand is optional. -message msg Specifies the user-defined message for the test e-mail. This operand is optional. --import Imports a flow from Flow Vision into MAPS. flow_name Specifies the name of a flow to be imported. The flow name must be defined in Flow Vision. This operand is required. -force Imports a flow with the same name as the previously imported flow. This operand is optional. When a flow that was imported into MAPS is deleted in Flow Vision, all members of the group corresponding to that flow are automatically deleted from MAPS. If the same flow is created again, it will not automatically be reimported into MAPS, and importing this flow using the --import option fails unless you use the -force option. 510 Brocade Fabric OS Command Reference 53-1004112-02