Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 1050

snmpConfig 1026 snmpv1 Selects SNMPv1-related configuration parameters. These parameters include the community string, trap recipient IP address, and trap severity level associated with each trap recipient IP address. When "0" is configured as a trap port, traps can be received at the default port 162. snmpv3 Selects SNMPv3-related configuration parameters. These parameters include the user name, authentication protocol and password, the privacy protocol and password, the SNMPv3 trap recipient's IP address, its associated user index, and trap severity level. When "0" is configured as a trap port, traps can be received at the default port 162. -index index Specifies the index for which the user details are configured. Vaild values are from 1 through 6. -community community_name Specifies the community string. If special characters are used in the community_name, the community_name must be enclosed in single quotes. The default values for the community strings include the following: • Community 1: Secret Code • Community 2: OrigEquipMfr • Community 3: private • Community 4: public • Community 5: common • Community 6: FibreChannel -host [ipv4 | ipv6 | dns] Specifies the IP address of the host. IPv4, IPv6, and DNS hosts are supported. -port udp_port Specifies the UDP port where SNMP traps will be received. Valid port IDs range from 0 through 65535. The default port is 162. -severity severity_level Specifies the trap recipient severity level. When an event occurs and its severity level is at or below the set value, the Event Trap traps (swEventTrap and connUnitEventTrap), are sent to configured trap recipients. By default, this value is set at 0, implying that no Event Trap is sent. Possible values are: --default • 0: None • 1: Critical • 2: Error • 3: Warning • 4: Informational • 5: Debug Sets the SNMP agent configuration data for a specified item to the default values. Generally, these default values may be available in the configuration database. The command sets to factory defaults if the SNMP agent configuration parameters are not available in the configuration database. This operand is valid only with snmpv1. Brocade Fabric OS Command Reference 53-1004112-02