Dell Brocade G620 Brocade 8.0.1 Fabric OS Command Reference - Page 131

chassisBeacon chassisBeacon Sets chassis beaconing mode. Synopsis chassisbeacon [mode] Description Use this command to enable or disable beaconing on a chassis. Chassis beaconing can be used to locate a failing chassis in a group of chassis. Use the portBeacon command to locate a failing port, and use the switchBeacon command to locate a failing (logical) switch. When beaconing mode is turned on, the port LEDs flash green at various rates across the chassis. The beaconing continues until you turn it off. Beaconing mode takes over the port LEDs. The normal flashing LED pattern associated with an active, faulty, or disabled port is suppressed, and only the beaconing pattern is shown. Other commands are still executable and functional. However, if diagnostic frame-based tests such as portLoopbackTest are executed, the diagnostic LED pattern is interleaved with the beaconing pattern. The chassisBeacon command is one of the commands that control beaconing. Each command has a clearly defined scope of action: • The portBeacon command enables or disables beaconing on a specified port. • The switchBeacon command enables or disables beaconing on all ports in the current logical switch. • The chassisBeacon command enables or disables beaconing on all ports in the chassis. • The portPeerBeacon command enables or disables beaconing to identify the interconnections between ports. The actions of the beaconing commands are independent and mutually exclusive. For example, if you enabled beaconing on the logical switch and you want to enable beaconing on the entire chassis, you must first disable switch beaconing with the switchBeacon command before you can use the chassisBeacon command to enable beaconing on the entire chassis. Likewise, existing portBeacon settings remain unaffected if you enable or disable beaconing on the switch or on the chassis. Failure to disable existing beaconing commands before using a different type of beaconing may cause the commands to interfere with each other in unexpected ways. On a Brocade X6 Director, enabling chassis beaconing activates beaconing on CP blades also. To determine whether or not beaconing is enabled or disabled on the switch or chassis, use the switchBeacon or chassisBeacon command without operands. A value of 0 indicates that the command is disabled, a value of 1 indicates that the command is enabled. Issue the portBeacon --show command to display beaconing for a specific port. The switchShow command displays the status of the switchBeacon command only. Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric OS Commands" and "Command Availability" for details. Operands This command has the following operand: mode Specify 1 to enable chassis beaconing mode or 0 to disable beaconing mode. This operand is optional. If no operand is specified, the current value is displayed. Brocade Fabric OS Command Reference 107 53-1004112-02