Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1019

Usage Information Version 9.14(1.0) Description Introduced on the C9010, MXL, FN IOM, S3100 series, S4810, S4820T, S3048-ON, S4048-ON, S4048T-ON, S5048F-ON, S6000, S6000-ON, S6010-ON, S6100-ON, Z9100-ON, and Z9500. Only if you enable the port security, you will be able to configure MAC address learning limit configurations on the interface level. When you disable the port security, all the interface level configurations are reset. Also, all dynamically learnt MAC addresses on the interfaces configured with MAC address learning limit are cleared. show cam mac linecard (dynamic or static) Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs. C9000 Series Syntax Parameters show cam mac linecard slot-id port-set port-pipe [address mac_addr | dynamic | interface interface | static | vlan vlan-id] linecard slot-id port-set portpipe address macaddr dynamic interface interface (REQUIRED) Enter the keyword linecard then a slot number to select the linecard for which to gather information. The range of C9000 slot IDs are from 0 to 11. (REQUIRED) Enter the keywords port-set then a port-pipe number to specify the port pipe for which to gather information. The range of port pipe numbers is from 0 to 0. (OPTIONAL) Enter the keyword address then a MAC address in the nn:nn:nn:nn:nn:nn format to display information on that MAC address. (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses the switch dynamically learns. (OPTIONAL) Enter the keyword interface then the interface type, slot and port information: ● For a Port Channel interface, enter the keywords port-channel then a number. ● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. ● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. ● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48. ● For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the portid range is 25 to 28 or 49 to 52 depending on the PE. static vlan vlan-id (OPTIONAL) Enter the keyword static to display only those MAC addresses specifically configured on the switch. (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC address assigned to the VLAN. The range is 1 to 4094. Command Modes ● EXEC ● EXEC Privilege Layer 2 1019