Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 946

Example (Summary) N2- OSPF NSSA external type 2, E1 - OSPF external type 1 E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1 L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default >- non-active route + - summary route Gateway of last resort is not set Destination Gateway Dist/Metric Last Change R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12 via 101.10.10.10, So 2/9 100.10.10.0/24 Direct, Te 2/8 0/0 00:08:54 > R 100.10.10.0/24 Direct, Te 2/8 120/0 00:08:54 C 101.10.10.0/24 Direct, Te 2/9 0/0 00:09:15 > R 101.10.10.0/24 Direct, Te 2/9 120/0 00:09:15 Dell# Dell#show ip route summary Route Source Active Routes Non-active Routes connected 2 0 static 1 0 Total 3 0 Total 3 active route(s) using 612 bytes Dell#show ip route static Destination Gateway ----------- ------- *S 0.0.0.0/0 via 10.10.91.9, Te 1/2 Dist/Metric Last Change 1/0 3d2h show ip route list Display IP routes in an IP prefix list. C9000 Series Syntax Parameters show ip route list prefix-list prefix-list Enter the name of a configured prefix list. Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. 946 IPv4 Routing