Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1236

NOTE: The parameters vrf, mac-address, interface are not supported in the batch mode. ipv6 ospf area Enable IPv6 OSPF on an interface. C9000 Series Syntax Parameters ipv6 ospf process id areaarea id To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id area area-id command. process-id area area-id Enter the process identification number. Specify the OSPF area. The range is from 0 to 4294967295. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.14(0.2) 9.9(0.0) 9.2(1.0) 9.1.(0.0) 8.3.19.0 7.4.1.0 Increased the area ID value from 65535 to 4294967295. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4810 and Z9000. Introduced on the S4820T. Introduced on the E-Series and C-Series. ipv6 ospf authentication Configure an IPsec authentication policy for OSPFv3 packets on an IPv6 interface. C9000 Series Syntax Parameters ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1} [keyencryption-type] key}} null Causes an authentication policy configured for the area to not be inherited on the interface. ipsec spi number Security Policy index (SPI) value that identifies an IPsec security policy. The range is from 256 to 4294967295. MD5 | SHA1 Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1). key-encryptiontype (OPTIONAL) Specifies if the key is encrypted. Valid values: 0 (key is not encrypted) or 7 (key is encrypted). key Text string used in authentication. 1236 Open Shortest Path First (OSPFv2 and OSPFv3)