Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1410

Table 8. Default Mapping dot1p 0 1 2 3 4 5 6 7 Queue ID 1 0 2 3 4 5 6 7 Command Modes INTERFACE CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 7.5.1.0 6.5.1.0 6.1.1.1 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added the kbps option on the C-Series, E-Series, and S-Series. Introduced on the S-Series. Introduced on the C-Series. Expanded the command to permit configuration on port channels. Introduced on the E-Series. Usage Information To honor all incoming 802.1p markings on incoming switched traffic on the interface, enter this command. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic are not honored). You can apply this command on both physical interfaces and port channels. When you set the serviceclass dynamic for a port channel, the physical interfaces assigned to the port channel are automatically configured; you cannot assign the service-class dynamic command to individual interfaces in a port channel. ● All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command on an interface or globally. ● Layer 2 or Layer 3 service policies supersede dot1p service classes. Use this command in Configuration Terminal Batch mode to honor the incoming 802.1p markings in a dualhoming setup. 1410 Quality of Service (QoS)