Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 67

Usage Information Version 9.9(0.0) 9.2(1.0) 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the E-Series. Enables periodic audits of the software and hardware copies of the IPv4 forwarding table. Use this command in Configuration Terminal Batch mode to enable the audits in the chassis connected in a dualhoming setup. clear alarms Clear alarms on the system. C9000 Series Syntax clear alarms Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.6.1.0 7.5.1.0 E-Series Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Original command. Usage Information This command clears alarms that are no longer active. If an alarm situation is still active, it is seen in the system output. clear average-power Reset the average power and average power start time. Syntax Parameters clear average-power stack-unit {stack-unit-number} stack-unitnumber Enter the stack unit number. Defaults None Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Control and Monitoring 67