Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 921

Usage Information Related Commands Version 7.6.1.0 7.5.1.0 6.3.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced for the E-Series. This command disables the hop field increments when boot requests are relayed to a DHCP server through the system. If the incoming boot request already has a non-zero hops field, the message is relayed with the same value for hops. However, the message is discarded if the hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542. ● ip helper-address - specifies the destination broadcast or host address for DHCP server requests. ● show running-config - displays the current configuration and changes from the default values. ip host Assign a name and IP address for the host-to-IP address mapping table. C9000 Series Syntax Parameters ip host name ip-address To remove an IP host, use the no ip host name [ip-address] command. name ip address Enter a text string to associate with one IP address. Enter an IP address, in dotted decimal format, to be mapped to the name. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced for the E-Series. IPv4 Routing 921