Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 292

match origin To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter. C9000 Series Syntax Parameters match origin {egp | igp | incomplete} To disable matching filter, use the no match origin {igp | egp | incomplete} command. egp igp incomplete Enter the keyword egp to match routes originating outside the AS. Enter the keyword igp to match routes originating within the same AS. Enter the keyword incomplete to match routes with incomplete routing information. Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking TOS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the E-Series. match route-type To match routes based on the how the route is defined, configure a filter. C9000 Series Syntax Parameters match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local} To delete a match, use the no match route-type {local | internal | external [type-1 | type-2] | level-1 | level-2} command. external [type-1| type-2] internal level-1 level-2 local Enter the keyword external then either type-1 or type-2 to match only on OSPF Type 1 routes or OSPF Type 2 routes. Enter the keyword internal to match only on routes generated within OSPF areas. Enter the keyword level-1 to match IS-IS Level 1 routes. Enter the keyword level-2 to match IS-IS Level 2 routes. Enter the keyword local to match only on routes generated within the switch. 292 Access Control Lists (ACL)