Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 503

Version 9.9(0.0) Description Introduced on the C9010. Usage Guidelines Select the CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, and Policy-based Routing (PBR). Save the new CAM settings to the startup-config (write-memor copy run start) then reload the system for the new settings to take effect. The total amount of space allowed is 12 FP Blocks. System flow requires three blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to 4. When configuring space foripv6acl, the total number of Blocks must equal 13. Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM regions, the value is 0. cam-optimization Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space. C9000 Series Syntax Parameters cam-optimization [qos] qos Optimize CAM usage for QoS. Defaults Disabled. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.8.1.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ipprecedence rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is written (only one FP entry is used). Use this command in Configuration Terminal Batch mode to enable the settings in a dual-homing setup. NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of interfaces. For more information, refer to the "IP Access Control Lists", "Prefix Lists", and "Route- map" sections in the Dell Networking OS Configuration Guide. Content Addressable Memory (CAM) 503