Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1492

network Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this command. C9000 Series Syntax Parameters network ip-address To disable RIP for a network, use the no network ip-address command. ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. Defaults No RIP network is configured. Command Modes ROUTER RIP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information You can enable an unlimited number of RIP networks. RIP operates over interfaces configured with any address the network command specifies. offset-list Specify a number to add to the incoming or outgoing route metrics learned using RIP. C9000 Series Syntax Parameters offset-list prefix-list-name {in | out} offset [interface] To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command. prefix-list-name offset interface Enter the name of an established Prefix list to determine which incoming routes are modified. Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken. (OPTIONAL) Enter the following keywords and slot/port or number information: 1492 Routing Information Protocol (RIP)