Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 680

Usage Information Example Related Commands Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series. Introduced. Executing this command without the optional ring-id command clears the statistics counters on all the available rings. The system requires a command line confirmation before the command executes. This command clears the following counters: ● hello Rx and Tx counters ● Topology change Rx and Tx counters ● The number of state change counters Dell# clear frrp Clear frrp statistics counter on all ring [confirm] yes Dell#clear frrp 4 Clear frrp statistics counter for ring 4 [confirm] yes Dell# show frrp - displays the Resilient Ring Protocol configuration. debug frrp Clear the FRRP statistics counters. C9000 Series Syntax Parameters debug frrp {event | packet | detail} [ring-id] [count number] To disable debugging, use the no debug frrp {event | packet | detail} {ring-id} [countnumber] command. event packet detail ring-id count number Enter the keyword event to display debug information related to ring protocol transitions. Enter the keyword packet to display brief debug information related to control packets. Enter the keyword detail to display detailed debug information related to the entire ring protocol packets. (Optional) Enter the ring identification number. The range is from 1 to 255. Enter the keyword count then the number of debug outputs. The range is from 1 to 65534. Defaults Disabled. Command Modes CONFIGURATION (conf-frrp) 680 Force10 OS Resilient Ring Protocol (FRRP)