Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1482

debug ip rip Examine RIP routing information for troubleshooting. C9000 Series Syntax Parameters debug ip rip [interface | database | events [interface] | packet[interface] | trigger] To turn off debugging output, use the no debug ip rip command. interface database events packet trigger (OPTIONAL) Enter the interface type and ID as one of the following: ● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. ● For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128. ● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. ● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. ● For a VLAN, enter the keyword vlan then a number from 1 to 4094. (OPTIONAL) Enter the keyword database to display messages when there is a change to the RIP database. (OPTIONAL) Enter the keyword events to debug only RIP protocol changes. (OPTIONAL) Enter the keyword packet to debug only RIP protocol packet. (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. 1482 Routing Information Protocol (RIP)