Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1362

Usage Information Example The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) Introduced on the C9010. The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in a dual-homing environment. Use the commit command to apply the configuration changes. In the Configuration Terminal Batch mode, you can continue to commit the changes without exiting the batch mode. Example with multiple Commits: Dell#configure terminal batch Peer is registered Dell(conf-b)#interface peGigE 184/0/1 Dell(conf-b-if-pegi-184/0/1)#no shutdown Dell(conf-b-if-pegi-184/0/1)#commit Dell(conf-b)#Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress Apr 5 06:48:28: %RPM1-P:CP %IFMGR-5-ASTATE_UP: Changed interface Admin state to up: PeGi 184/0/1 Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is success Dell(conf-b)#interface peGigE 184/0/1 Dell(conf-b-if-pegi-184/0/1)#switchport Dell(conf-b-if-pegi-184/0/1)#int vla 1000 Dell(conf-b-if-vl-1000)#tagged peGigE 184/0/1 Dell(conf-b-if-vl-1000)#commit Dell(conf-b)#Apr 5 06:48:47: %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress Apr 5 06:48:47: %RPM1-P:CP %IFMGR-5-ACTIVE: Changed Vlan interface state to active: Vl 1000 Apr 5 06:48:48: %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is success commit write Use commit write to apply the common configurations made in the Configuration Terminal Batch mode and to save the running configuration in both VLT peers. C9000 Series Syntax commit write Parameters None Default None Command Modes CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.13(0.0) Introduced on the C9010. Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in a dual-homing environment. Use the commit write command to apply the configuration 1362 Port Extenders (PE)