Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1138

38 Object Tracking Object Tracking supports IPv4 and IPv6 protocols. Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object's state occurs. The following tracked objects are supported: ● Link status of Layer 2 interfaces ● Routing status of Layer 3 interfaces (IPv4 and IPv6) ● Reachability of IPv4 and IPv6 routes ● Metric thresholds of IPv4 and IPv6 routes You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state of a tracked object changes. This chapter contains the following sections: ● IPv4 Object Tracking Commands ● IPv6 Object Tracking Commands Topics: • IPv4 Object Tracking Commands • IPv6 Object Tracking Commands IPv4 Object Tracking Commands The following section describes the IPv4 object tracking commands. debug track Enable debugging for tracked objects. C9000 Series Syntax Parameters debug track [all | notifications | object-id] all notifications object-id Enables debugging on the state and notifications of all tracked objects. Enables debugging on the notifications of all tracked objects. Enables debugging on the state and notifications of the specified tracked object. The range is from 1 to 500. Defaults Enable debugging on the state and notifications of all tracked objects (debug track all). Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) Introduced on the C9010. 1138 Object Tracking