Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1602

Usage Information Version 9.8(0.0P2) 9.7(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 8.1.1.0 7.7.1.0 7.6.1.0 6.2.1.1 Description Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced S-Series Stacking. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual interfaces where sFlow sampling is desired. Use this command in Configuration Terminal Batch mode to enable sFlow in a dual-homing setup. sflow enable (Interface) Enable sFlow on interfaces. C9000 Series Syntax sflow enable To disable sFlow, use the no sflow enable command. Defaults Disabled. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.16.1 8.3.11.1 8.3.7.0 8.2.1.0 8.1.1.0 7.7.1.0 7.6.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the MXL 10/40GbE Switch IO Module. Introduced on the Z9000. Introduced on the S4810. Introduced on S-Series Stacking. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. 1602 sFlow