Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1498

Usage Information Example Related Commands Version 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Description Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. To enable RIP, assign a network address using the network command. Dell(conf)#router rip Dell(conf-router_rip)# network - enables RIP. exit - returns to CONFIGURATION mode. show config Display the changes you made to the RIP configuration. The default values are not shown. C9000 Series Syntax show config Command Modes ROUTER RIP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf-router_rip)#show config ! router rip network 172.31.0.0 passive-interface TenGigabitEthernet 0/1 Dell(conf-router_rip)# 1498 Routing Information Protocol (RIP)