Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1312

Usage Information Version 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 Description Introduced on the S6000-ON. Added support for VRF. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Introduced The access name is an extended IP access list that denies PIM register packets to RP at the source DR based on the multicast and group addresses. Do not enter this command before creating the access-list . ip pim rp-address Configure a static PIM rendezvous point (RP) address for a group or access-list. C9000 Series Syntax Parameters ip pim rp-address address {group-address group-address mask} [override] To remove an RP address, use the no ip pim rp-address address {group-address groupaddress mask} [vrf vrf-name] [override] command. address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keywords group-address then a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override takes effect immediately during enable/disable. NOTE: This option is applicable to multicast group range. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added support for VRF. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. 1312 PIM-Sparse Mode (PIM-SM)