Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1393

show config Display the current monitor session configuration. C9000 Series Syntax show config Defaults none Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.7.0 8.3.11.1 8.1.1.0 7.7.1.0 7.5.1.0 7.4.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf-mon-sess-2)#show config ! monitor session 2 type rpm source fortyGigE 0/60 destination remote-vlan 300 direction rx source Port-channel 10 destination remote-vlan 300 direction rx no disable Dell# show monitor session Display port extender (PE) Gigabit Ethernet interface monitoring information. C9000 Series Syntax Parameters Defaults show monitor session {session-ID} To display monitoring information for all sessions, use the show monitor session command. To display monitoring information for port extender interface, when added as a source port, use the do show monitor session command in CONFIGURATION mode. session-ID (OPTIONAL) Enter a session identification number. The range is from 0 to 65535. none Port Monitoring 1393