Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1683

storm-control unknown-unicast (Interface) Configure percentage of unknown-unicast traffic allowed on an interface (ingress only). C9000 Series Syntax Parameters storm-control unknown-unicast [percentage decimal_value in] | [wred-profile name]] [packets_per_second in] To disable unknown-unicast storm control on the interface, use the no storm-control unknownunicast [percentage decimal_value in] | [wred-profile name]] [packets_per_second in] command. percentage E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the decimal_value [in network. Optionally, you can designate a decimal value percentage, for example, | out] 55.5%. The percentage is from 0 to 100: ● 0% blocks all related traffic. ● 100% allows all traffic into the interface. The decimal range is from 0.1 to 0.9. wred-profile name E-Series Only: (Optionally) Enter the keywords wred-profile followed by the profile name to designate a wred-profile. packets_per_sec C-Series and S-Series Only: Enter the packets per second of broadcast traffic ond in allowed into the network. The range is from 0 to 33554431. Defaults none Command Modes INTERFACE (conf-if-interface-slot/port) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 7.4.1.0 6.5.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. E-Series Only: Added the percentage decimal value option. Introduced on the E-Series. Storm Control 1683