Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 722

Usage Information Example Related Commands Version 6.4.1.0 Description Introduced You cannot delete a Management port. The Management port is enabled by default (no shutdown). To assign an IP address to the Management port, use the ip address command. If your system has two RPMs installed, use the show redundancy command to display which RPM is the Primary RPM. Dell(conf)# interface managementethernet 0/0 Dell(conf-if-ma-0/0)# management route - configures a static route that points to the Management interface or a forwarding router. speed (Management interface) - clears the FIB entries on a specified line card. interface null Configure a Null interface on the switch. C9000 Series Syntax Parameters interface null number number Enter zero (0) as the Null interface number. Defaults Not configured; number = 0 Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.4.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced Usage Information Example You cannot delete the Null interface. The only configuration command possible in a Null interface is ip unreachables. Dell(conf)# interface null 0 Dell(conf-if-nu-0)# 722 Interfaces