Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1361

Dual Homing Use the commands in the following section to setup the configurations on a port extender connected in a dual-homing environment. batch-write-memory Saves the running configuration in both the VLT peers. Syntax batch-write-memory Parameters None Defaults None Command Modes CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.13(0.0) Introduced on the C9010. Usage Information Example If the batch-write-memory command fails on one of the VLT peers, it does not affect the operation in the other VLT peer. Instead, an appropriate error message is displayed. Primary VLT DellEMC(conf-b)#batch-write-mem DellEMC(conf-b)#Dec 6 11:33:35 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by default Dec 6 11:33:36 %RPM1-P:CP %CLIBATCH-6CLIBATCH_PEER_CONFIG_WRITE_COMPLETE: Copy of running-config to startupconfig in VLT peer flash is successful Secondary VLT DellEMC#Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch configuration commit is success Dec 6 10:44:31 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by default Dec 6 10:46:08 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by default commit Use commit to apply the common configurations made in the Configuration Terminal Batch mode. C9000 Series Syntax commit Default None Command Modes CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Port Extenders (PE) 1361