Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 654

Command History Usage Information Related Commands Version 9.9(0.0) 9.2(1.0) 9.0.0.0 8.3.10.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S4810. You must save the new ECMP settings to the startup-config (write-mem) then reload the system for the new settings to take effect. show ip cam linecard - Display content-addressable memory (CAM) entries for a set of ports on a line card. ip ecmp weighted Enables weighted ECMP calculations. C9000 Series Syntax ip ecmp weighted To disable weighted ECMP calculations, enter the no ip ecmp weighted command. Defaults N/A Command Modes CONFIGURATION Command History Version 9.9(0.0) 9.7(0.0) Description Introduced on the C9010. Introduced on the S-Series. Usage Information Example Enabling this CLI would inform the FIB to re-program the destination prefix paths with weights in the HW/CAM on the fly. If disabled, the CLI would inform the FIB to re-program the destination prefix paths with no weights or regular ECMP. Dell(conf)#ip ecmp ? weighted Enables Weighted ECMP Dell(conf)#ip ecmp weighted Dell(conf)#do show running-config | grep ecmp ip ecmp weighted Dell(conf)# Dell(conf)#no ip ecmp ? weighted Disables Weighted ECMP Dell(conf)#no ip ecmp weighted Dell(conf)#do show running-config | grep ecmp link-bundle-distribution trigger-threshold Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on an ECMP link bundle. C9000 Series Syntax link-bundle-distribution trigger-threshold [percent] 654 Equal Cost Multi-Path (ECMP)