Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 786

management egress-interface-selection To make configured application traffic egress through the management port instead of the front-end (FE) port, enable and configure a management egress interface. C9000 Series Syntax management egress-interface-selection To disable and remove management egress interface selection (EIS) configurations, use the no management egress-interface-selection command. Defaults None. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.2(0.0) Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000, S4810, and S4820T. show ip management-eis-route Display the management routes used by EIS. C9000 Series Syntax show ip management-eis-route Defaults None. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.2.(0.0) Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000, S4810, and S4820T. Example Dell# show ip management-eis-route Destination Gateway ----------- ------- 10.11.0.0/16 ManagementEthernet 0/0 172.16.1.0/24 10.11.192.4 State ----Connected Active Route Source -----------Connected Static 786 Interfaces