Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 229

monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the Dell Networking OS Configuration Guide. Defaults Not configured. Command Modes CONFIGURATION-STANDARD-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 7.4.1.0 6.5.10 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Add the DSCP value for ACL matching. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Added support for the non-contiguous mask and added the monitor option. Expanded to include the optional QoS order priority for the ACL entry. Usage Information Related Commands Use the order option only when you use policy-based QoS on the switch. For more information, refer to the Quality of Service chapter of the C9000 Series Configuration Guide. When you use the log option, the CP processor logs detail the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled. Use the monitor option only when you are using flow-based monitoring. For more information, refer to the Port Monitoring chapter of the C9000 Series Configuration Guide. deny - Assigns a IP ACL filter to deny IP packets. ip access-list standard - creates a standard ACL. resequence access-list Re-assign sequence numbers to entries in an existing ACL. C9000 Series Syntax Parameters resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum Step-to-Increment} ipv4 | ipv6 | mac Enter the keyword ipv4, ipv6 or mac to identify the access-list type to resequence. Access Control Lists (ACL) 229